But remember that you need to access a directory before it is auto-mounted. Once it has been accessed, your share will be listed only until it times out.I've installed a minimal installation of Red Hat 9 in VMware Workstation 5.5.3 and it worked fine. One great thing about Linux is that you can transplant a hard disk from a machine that runs a 32-bit AMD XP processor into a new 64-bit Intel Core 2 machine, and the Linux installation will continue to work.However, if you do this, you'll be running a 32-bit kernel, a C library, and a complete system install on a processor that could happily run 64-bit code.stores the label in the last sector of a given provider, the label will remain persistent across reboots.By using this label as a device, the file system may always be mounted regardless of what device node it is accessed through.Perform this at your own risk after creating a suitable backup.
Here's what does work: 1) The share mounts if I select mount from the entry Systems | Disk and Network Filesystem through Webmin once the machien has started up fully 2) Once booted the share mounts by running: mount -a So I'm pretty certain that the syntax in fstab is correct.
By permanently labeling the partitions on the boot disk, the system should be able to continue to boot normally, even if the disk is moved to another controller or transferred to a different system.
autofs is a program for automatically mounting directories on an as-needed basis.
For example, consider the following master map entry: In this howto, we will configure autofs to auto-mount an NFS share, using a set of configuration files.
This howto assumes that you are already familiar with NFS exports, and that you already have a properly-functioning NFS share on your network.